Kwikflo Oil/Water Separators are used to remove grease/oil and solid matter from wash down water, thus preventing contaminants from entering stormwater and sewerage systems. 

A 240v diaphragm pump draws oily/dirty water from the collection pit and into the Separator. The contaminated fluid enters the inlet chamber where heavy solids settle and fall under gravity to the

hopper below, a drain valve allows these solids to be collected for disposal. The remaining oily fluid passes through a series of vertical

polypropylene closely spaced coalescing plates. The plates separate the oil slugs which rise immediately to the surface and move down stream to a baffle or oil dam and are collected in the 20litre oil drum. 

The treated fluid then gravity drains to the sewer or to a holding pit where a submersible pump can transfer it to the sewer or tanker. 

A 240v Control Panel with isolating switch, lead and plug is included and connects the pump’s motor & the float switch. The float switch,

installed in the collection pit, starts/stops the pump on water level  rise/fall. The float switch has a 10m lead and operates on 24 volt AC.

A comprehensive operating/instruction manual included.

 Typical applications:

Car Washers,Panel Beaters,Service Stations,Mechanical Workshops,Fuel Depots

Truck/Bus Wash Bays,Earthmoving Machinery Storage Areas,Forecourts

or anywhere that generates hydrocarbon contaminated waste water